Manley Mono Microphone Preamplifier
Manely All-Tube Microphone Preamplifieris available in single-channel version. This all-tube mic preamplifier delivers a tight bass and a crisp top end, for a sound that is nothing short of amazing. But the Manley Mic Pre isn't "just" for vocals! A DIRECT INPUT jack lets all kinds of instruments, from bass to keyboards to drum machines, experience that tube warmth. You can also change the speed, placement, and tonal balance of your sound. This is great for adding character to your music, making it mellow with more tube, or giving it a punchier, more aggressive spark.
MANLEY input & output transformers with nickel laminations in mu-metal cases
Flat frequency response from 10Hz-60KHz
Mic input PHASE REVERSE switch
2400 Ohm mic input Z; 48V phantom power built-in
Hi-Z (100 kOhm) 1/4" DIRECT INPUT
Noiseless conductive plastic INPUT attenuators
<0.05% THD @ 1kHz S/N ratio: 80dB
Adjustable FEEDBACK / GAIN switch selects 5dB steps between 40 to 60 dB of gain
Hi-current drive <50 Ohm LO-Z 1/4" & XLR outputs
AUTO MUTE w/ warm-up delay for power up/down
Max. input (with input pad fully open): 450mV
Max. output: +32dBu
Max. output (into 600 Ohm load): (+15dBm)
Power consumption Mono units: 18 watts; Dual Mono units: 36 watts
Operating mains voltage: Units are purpose built for original destination country's mains voltage: 100V, 120V, or 220-240VAC as indicated on the serial number badge. Power transformer must be replaced in order to change mains operating voltage. 120VAC units may NOT be rewired to put the primaries of the power transformer in series for 220-240V operation or a large radiated field of hum will develop. If changing locations/voltages, the power transformer must be replaced with the dedicated one for the voltage at which it will operate.
Mains Voltage Frequency: 50~ 60Hz
Dimensions: 19" x 1 3/4" x 10" (occupies 1u)
Shipping Weight: 12 lbs.
Be the first to Write a Review