Tascam TM-200SG Shotgun Microphone is a compact, highly directional shotgun microphone. The supercardioid condenser element enables it to deliver focused sound pickup with far less background noise than the omni-directional mics usually built into cameras. The Tascam TM-200SG offers a frequency response from 30 Hz to 20 kHz. Also this mic is basically intended for vlogging, video shooting and other applications where built-in mics aren’t an option.
Phantom-powered and lightweight, the Tascam TM-200SG includes a switchable low-cut filter for reduction of environmental noise like wind and hum. It utilizes a balanced XLR 3-pin output connector and runs on standard 48 VDC phantom power. Most importantly, Tascam TM-200SG ships with a windscreen, shoe-mount clip, and protective soft case.
Gives you clean, isolated voice pickup without crowding a shot
Great for location-based sound design or studio-based vlogging and voiceovers
Finely detailed back-electret condenser element
Supercardioid directivity for focused, clean audio
The TASCAM TM-200SG intelligently recognizes the audio you want to capture while leaving unwanted sounds behind. Post-production is a breeze with audio captured by the TASCAM TM-200SG.
Hones in on dialog at a distance and in noisy environments
Full-range 30Hz-20kHz audio reproduction
160Hz low-cut filter combats wind and handling noise
Lightweight and compact design
TASCAM TM-200SG was designed to be heard, not seen. The perfect balance of audio replication and small form factor mean this microphone will be the least of your worries while shooting in the field.
Includes a soft carry case, mic clip with shoe mount, and foam windscreen
Requires +48V phantom power
Form Factor: Stand/Boom Mount
Sound Field: Mono
Operating Principle: Pressure Gradient
Capsule: Electret: Condenser
Polar Pattern: Supercardioid
Orientation: End Address
High-Pass Filter: 160 Hz, 3 dB/Octave
On-Board Controls: High-Pass Filter
Windscreen: Foam (Included)
Frequency Range: 30 Hz to 20 kHz
Maximum SPL: 132 dB SPL (1 kHz, 1% THD)
Impedance: 200 Ohms ± 30% at 1 kHz
Sensitivity: -40 dBV/Pa at 1 kHz
Signal-to-Noise Ratio: 74 dB (1 kHz)
Output Connectors (Analog): 1 x XLR 3-Pin Male (on Mic)
Operating Voltage: 48 V (Phantom Power)
Mounting: 1/4″-20 Female, Camera/Shoe-Mount (with Included Hardware)
Dimensions: ø: 0.9 x L: 6″ / ø: 23 x L: 153 mm
Weight: 1.9 oz / 53 g