Radial Engineering Shotgun 4-channel Guitar Amp Driver

Radial Engineering Shotgun 4-channel Guitar Amp Driver

$219.99
Out of stock
Qty:
SKU: RESHOTGUN Category:

Radial Engineering Shotgun 4-channel Guitar Amp Driver makes it easy to drive multiple amplifiers cleanly and in phase without buzz or hum from ground loops. In mono operation, connect to input-1 of the Shotgun and you can feed up to four amps simultaneously. For stereo setups, the Shotgun automatically reconfigures when both inputs are used; feeding input-1 to the first two amplifiers, and input-2 to the second pair. Isolation transformers and ground lifts are included on the outputs to eliminate ground loop noise, along with 180° polarity reverse switches to ensure all amps are phase-matched.

Features

Guitar-level signal buffer drives up to 4 guitar amps

Select between 1 x 4 mono and 2 x 2 stereo configuration

Isolated outputs eliminate hum and buzz due to ground loops

Buffered outputs easily drive extra-long cable runs

Radial’s Consistent Load Compensation (CLC) circuit

Powered via standard 9-volt supply or multi-pedal power brick

Specifications

Audio Circuit Type: Buffered signal distribution with 3x isolated outputs

Frequency Response: 20 Hz to approximately 20 kHz

Dynamic Range: 92 dB

Noise Floor: -86 dBu

Equivalent Input Noise: -90 dBu

Maximum Input: 8 dBu

Total Harmonic Distortion: < 0.02% at -20 dB

Inter-Modulation Distortion: Approximately 0.02%

Input Impedance: 220 kOhms

Output Impedance: 1.8 kOhms

Gain: 0 dB / -0.2 dB

Output Clip Level: +4 dBu

Switches:

3x Ground Lift
3x Phase Invert

Power: 9 VDC – 25 mA, center negative

Construction: 16-gauge steel chassis and outer shell

Environmental Conditions: For use in dry locations between 41 to 104°F / 5 to 40°C

Dimensions (LxWxH): 4.5 x 3.5 x 1.4″ / 111.4.3 x 92.0 x 34.8 mm

Weight: 1.1 lb / 0.5 kg

Related products