Rane HC 6S Headphone Amplifier
Rane HC 6Sfeatures 6 stereo headphone amplifiers that can deliver standard distribution or work as separate amplifiers (or any combination of both) for customized headphone mixes.
The HC 6S's Master stereo Inputs can be used to drive any or all of the six stereo headphone amps. On the front panel, a Mono switch is provided to drive both channels of all 6 amplifiers from a common mono source. Six individual unbalanced stereo Inputs are available to drive any individual amplifier from a separate stereo source. These Inputs can be converted to mono balanced Inputs through internal jumpers if needed. Outputs for all six channels are provided both on the front panel and on the rear panel so that headphones may be connected on either side based on the requirements of a given installation. Two pairs of headphones may be driven from each channel, one pair connected to the front and one to the rear.
The HC 6S can deliver up to 500 milliwatts into headphones with rated impedances between 32-600 ohms. The precise amount of power counts on the exact impedance of the headphone in use and the number of headphones connected to the unit. The HC 6S produces sound pressure levels in excess of 120 dB under most conditions. This level is more than adequate for most listeners.
Six Independent Stereo Headphone Amplifiers
Master Balanced/Unbalanced Stereo Inputs with Master Level
Six Unbalanced Stereo Inputs
Front and Rear Output Jacks
Six Output Level Controls
Internal Universal Power Supply (100-240 VAC)
Number of Channels: 6
Input Connectors:1 x 1/4" Stereo Master Input (2 Jacks, L/R); 6 x 1/4" Stereo Aux Inputs; 1 x Power Input
Output Connectors: 6 x Front-Panel 1/4" Stereo Outputs; 6 x Rear-Panel 1/4" Stereo Outputs
Maximum Output Level: 500mW (32 Ohm Headphones)
Frequency Response: 20Hz - 20kHz
THD + N: 0.002%
Dimensions (WxHxD): 19 x 1.75 x 5.3" (483 x 45 x 135mm)
Weight: 9 lbs (4.1kg)
Be the first to Write a Review